Rotary hammer drill maintenance
Step 1: Cleaning
The more often you use your rotary hammer drill for drilling, the more likely it is that it has been exposed to a lot of dirt and construction dust. No matter how thorough you are when drilling a hole, every wall leaves its dusty mark on the device.
It is best to clean your rotary hammer drill after each completed project. Simply take a dry cotton cloth or an old kitchen towel and wipe the coarse dust, dirt and any oil residue from the housing. If deposits have settled in cracks or the air vents from the motor, you can blow hard, use a brush or "shoot" the dirt away with a compressed air gun.
Once the coarse dirt is gone, your rotary hammer drill is clean again – at least clean enough for us DIYers! And then you can move on to the next step: Care
Step 2: Care
Once you have removed dust and dirt from your device, you can take care of your rotary hammer drill at regular intervals. Fortunately, there's not much to do because all Einhell devices are optimally adjusted ex works and designed for a particularly long service life. But something you can do to protect the material is to apply a small amount of grease to the drill chuck or the SDS mount of the rotary hammer drill after every few uses. This keeps both the holder and the drills themselves running smoothly. Changing the drill bits is all the easier without any jamming or getting stuck.
Alternatively, after each use you can wipe the drill bit or chisel with a cloth that you have shaken a little grease, Ballistol or WD 40 onto. This not only helps to remove the dirt, but also keeps your machines and drills well-oiled in the long term.
While we are on the subject of "long-term": Time to make sure your rotary hammer drill is stored properly after maintenance.
Rotary hammer with case
Safely stowed away – in a sturdy case made of special plastic
Step 3: Storage
All rotary hammer drills from Einhell come in a sturdy case made of special resistant plastic. And this case is the ideal storage place for your rotary hammer drill. Once you have cleaned and lightly oiled your machine, you can simply put it away in the case.
Then keep it in a dry place, for example in your workshop, garage or in a well-ventilated cellar. Even if you don't use the rotary hammer drill for a longer period of time, it is well protected in the case and always ready for use when you need to drill a hole in a wall again.